Hog Slat Inc. Newton Grove, NC USA December 2022 13 GROW-DISK™ Feed System Connection of Conveyer Tube to Drive Unit (HSCD401) Attach the conveyer tube so that it butts up to the stainless steel tubing on both the inlet and outlet side of the drive unit. • Place a steel compression coupler over the welded steel tubing and the inlet/outlet of the drive unit and tighten hardware securely. Note: Make sure coupler is assembled facing downward as shown below to prevent water from entering. Connection of Conveyer Tube to Chain Disk Fill Hopper (HSCD304-4) Attach the welded steel tubing so that it butts up to the stainless steel tubing on both the inlet and outlet side of the Chain Disk Fill Hopper. • Place a steel compression coupler (5) over the welded steel tubing (6) and the inlet/outlet of the fill hopper (4) and tighten hardware securely. Note: Make sure coupler is assembled facing downward as shown below to prevent water from entering. Position coupler facing downward
RkJQdWJsaXNoZXIy MTA3MzU=