Hog Slat Inc. Newton Grove, NC USA December 2022 14 GROW-DISK™ Feed System Connection of Conveyer Tube to Feed Sensor Sight Tube (HSCD-900) In a location after the last drop but before the chain disk drive system, install the feed sensor Clear Tube. The clear tube (3) HSCD-900-2 installs in-line with the chain disk pipe as shown below. The orientation of the clear tube should be located so the direction arrows on the side of the tube points in the travel direction of the chain disk. Insert the chain disk feed pipe (4) from each side into the tube until it stops (approximately 2”). Secure the clear tube to the chain disk feed pipe using two pipe clamps (1) position near the outer edges of the clear tube. The clear tube has molded in ribs to provide the locations for the clamps. Next install HSCD-900-1 Feed Sensor mounting bracket (2) to the clear tube (3). Using two clamps (1) route the end of the clamp through the slots of the mounting bracket and secure to the clear tube as shown. HAND TIGHTEN THE CLAMPS WITH SCREWDRIVER OR NUT DRIVER ONLY. DO NOT USE POWER TOOLS TO TIGHTEN! For installation of the Feed Sensor, refer to section HS11 Feed Sensor. Arrows indicate the direction of the chain travel
RkJQdWJsaXNoZXIy MTA3MzU=