Hog Slat Inc. Newton Grove, NC USA December 2022 22 GROW-DISK™ Feed System GrowerSELECT HS660S Feed Line Drop Adaptor Installation 1. Determine the desired location for the Outlet Drop. Use a hole saw or uni-bit to drill outlet holes. All burrs should be removed after cutting so drop will perform properly. This is important on chain disk system as to not damage the chain disks or drop adapter. Reference Figures and Charts below. Model Item 1 Item 2 60 1-1/2” Dia. (40 mm) n/a 2. Tie an overhand knot in Cord provided located at center of Cord length. Assemble Cord with Knot into retainer pocket of the Shutoff making sure that cord is fully seated in slots. 3. Snap the Shutoff Assembly with Cord on the metal tubing of previously drilled or cut Outlet Hole. 4. Assemble (snap) the Outlet Adapter onto the metal tubing under the Shutoff Assembly over the Outlet Hole. Outlet Adapter should remain in place.
RkJQdWJsaXNoZXIy MTA3MzU=