Hog Slat Inc. Newton Grove, NC USA December 2022 27 GROW-DISK™ Feed System GrowerSELECT Feed Line Sow Drop Installation Determine the desired location for the Outlet Drop. Use a hole saw or uni-bit to drill outlet holes. All burrs should be removed after cutting so drop will perform properly. This is important on chain disk system as to not damage the chain disks or drop adapter. Reference Figures and Charts below. Model Item 1 Item 2 60 1-1/2” Dia. (40 mm) n/a Adjustment Method – To change the capacity of the Sow Drop dispenser, a retractable wall is adjusted up and down by sliding the blue capacity indicator tab to meet the specified amount. Shut Off Operation – dispenser is equipped with a top slide which covers the top inlet hole preventing flow of feed. Pull the slide out will allow feed to flow. Feed Drop Method – In order to release the feed from the Sow Drop dispenser, a ball is pulled vertically by a cable which uncovers the hole in the bottom of the feeder.
RkJQdWJsaXNoZXIy MTA3MzU=