Hog Slat Inc. Newton Grove, NC USA December 2022 44 GROW-DISK™ Feed System o Move safety switch roller in one direction so that safety switch is activated and blue reset button is tripped. o Replace cover and turn power back on. • Put the HSCD200 Controller into the manual start position. If alarm indication is displayed, then safety switch is working properly. If not, disconnect power, inspect wiring and safety switch, and replace if necessary. • Turn power back off, remove cover, and pull blue reset button out to normal position, turn the Controller to manual stop, and acknowledge alarm on Controller is off. 4. Check Chain Tension of the System o Position the Safety Switch approximately 2 inches from the left side of bracket. This will prevent the initial startup movement from causing an erroneous activation of switch due to any slack in chain or stretching of chain. o Block the Door Switch (tape) and restart the drive unit and run it for 10-15 seconds. Caution: Make sure no one is in front of the drive unit and keeps their distance! o Check the position of the Chain Safety Switch during operation; it should be in the center of the safety bracket. o If not, turn off the drive unit and disconnect all electrical power to shorten the conveyer chain. (step 5) 5. Shorten conveyer chain if needed o Adjust the tensioning bolt inward on drive unit as far as possible towards the drive sprocket. o Remove the chain from the idler wheel and drive sprocket and cut it with a Grinder o Accordantly to the chain tension cut 1-3 chain disk links out of the loop. Chain sections attached with Coupler Tape wrapped on Coupler o Wrap one end of the chain around the idler wheel and the other end of chain onto the drive sprocket. o Connect the ends with chain coupler and mark with color adhesive tape for easy identification. o Readjust the tensioning bolt all the way back out so the Safety Switch bracket is capable of floating freely. o Reset Chain Safety Switch o Repeat this process until the correct chain tension is achieved
RkJQdWJsaXNoZXIy MTA3MzU=