BASE DIMENSIONS 4 EXHIBIT B EXHIBIT C EXHIBIT D CONNECTION TO WATER SUPPLY LINE: See Exhibit E. On models MC, MJ, and MK, the valve in your waterer is connected to part number MC180 - 1/2 x 1/4 reducing elbow. The elbow is connected to either a 1/2” x 7” galvanized nipple (MC) or a 1/2” x 12” galvanized nipple (MJ and MK). The valve, the elbow and the nipple are assembled in the waterer. Part number MC183 flex hose assembly is in the valve hardware bag. It is 6 inches long. Connect the female end of the flex hose assembly to the galvanized nipple in the waterer and then to your water supply on the other end (and / or preferably the shutoff valve (not included) you installed to the top of your water supply). The flex hose is included to prevent frost heave problems. Make sure pipe or flex hose do not touch an outside surface of the waterer or the heater. On model MH, the valve is connected to part number OP2 3/4” x 1/2” reducing elbow. The elbow is connected to a 1/2” x 17” galvanized nipple. Connect your water supply (or shutoff valve) with a flexible hose (not included). Use Teflon tape or a compatible plumbers’ paste on all connections. 5 MJ MC/MK MH
RkJQdWJsaXNoZXIy MTA3MzU=