GrowerSELECT - 1P Feed System Auger Power Drive Units Installation Manual

Hog Slat Inc. Newton Grove, NC USA April 2019 2 Grow Flex TM Feed System Wire Connection: Again, make sure that power is disconnected from system prior to servicing . This Power Unit is supplied prewired for 230 volt operation with the proper rotation direction for correct auger rotation. If 115 volt operation is required please see wiring instruction on Motor Data Label for converting to 115 volt operation. Black wire should connected to L1(M1) and White wire should connect to L2(M2). Green should be connected to Ground (See Figure 1) Figure 1 WARNING – ELECTRICAL SHOCK HAZARD! • Motor replacement and the associated wiring changes should only be made by qualified and properly trained individuals. • Failure to follow the above warning can cause improper equipment function, premature failure of equipment or electrical shock, leading to property damage or personal injury. Power Unit Assembly Part Numbers Part Number HP RPM Phase Hz Voltage Usages HS9020D1 1/3 352 Single 60 230 Model 55 Only HS9020D1-P 1/3 352 Single 60 230 Model 44 Poultry HS9021D1 1/2 352 Single 60 230 Model 55 Only HS9021D1-P 1/2 352 Single 60 230 Model 44 Poultry HS9021D8 1/2 256 Single 60 230 Models 75 & 90 HS9021D15 1/2 256 Single 60 230 Model 55 Only HS9021D15-P 1/2 256 Single 60 230 Model 44 Poultry HS9022D1 3/4 352 Single 60 230 Model 55 Only HS9022D1-P 3/4 352 Single 60 230 Model 44 Poultry HS9022D2 3/4 352 Single 60 230 Models 75 & 90 HS9022D10-P 3/4 693 Single 60 230 Model 44 Poultry HS9022D8 3/4 256 Single 60 230 Models 75 & 90 HS9023D2 1 352 Single 60 230 Models 75 & 90 HS9023D8 1 256 Single 60 230 Models 75 & 90 HS9023D17 1 156 Single 60 230 Models 75 & 90 HS9024D2 1 1/2 352 Single 60 230 Models 75 & 90 HS9024D8 1 1/2 256 Single 60 230 Models 75 & 90