Hog Slat Inc. Newton Grove, NC USA December 2019 8 Air Storm Fans Assembly 1. If a cone is required follow steps 2 through 5, if a cone is not required continue to step 6. 2. Remove grill guard from fan by removing all 4 bolts, washers, and nuts 3. Place the fan inlet side down on a level surface. Slide cone over exit orifice of the housing and align pre drilled holes. There is no orientation for the cone. (This step can also be completed after the fan is mounted in the wall) 4. Place the grill guard back into the cone and utilizing extended fasteners (supplied with fan), secure cone to housing by inserting the threaded portion of the bolt through the cone, then through the housing, then through the grill guard from the exterior of the fan. 5. Secure all 4 bolts with washers and nuts removed in step 2.
RkJQdWJsaXNoZXIy MTA3MzU=