Hog Slat Inc. Newton Grove, NC USA August 2019 11 Air Storm Fans Wiring and Electrical Installation General Installation Notes: Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Safety Instructions: Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Ground all electrical equipment for safety. Ground all non-current carrying metal parts to guard against electrical shock. ! WARNING ! Installation, operation, and maintenance must be performed by qualified personnel. All work should adhere strictly to the National Electrical Code and National Fire Protection Association standards. Additional Notes are below Connecting any voltage other than nameplate voltage can cause permanent damage to the unit. Insulate all connections carefully to prevent grounding or short circuits. Reinstall all conduit and terminal box covers. To avoid overheating or loss of performance, voltage to the motor control unit must be within plus or minus 10% of the nameplate voltage. Make sure the unit is electrically grounded and that proper electrical installation, wiring, and controls are used consistent with local and national electric codes. Code requirement differ from state to state. Install equipment using qualified electricians in accordance with applicable codes and ordinances in your area in accordance with NEC.
RkJQdWJsaXNoZXIy MTA3MzU=