Hog Slat Inc. Newton Grove, NC USA August 2019 12 Air Storm Fans Make sure there are no unusual noises or vibrations when the motor in running. Avoid contact with energized circuits or rotating parts. All aspects of the installation must conform to the applicable requirements of the NEC as well as local codes. Spinning the shaft will induce potentially damaging current to the drive and connections. Always disconnect electrical power at the fuse box or circuit breaker panel before handling electrical connections or performing maintenance on this unit. Allow the motor to come to a complete stop and wait ONE (1) MINUTE. This allows the capacitors to discharge any residual voltage. Double-check to make sure that electrical power is removed and that it cannot be turned on while you are working on the equipment. A poor electrical connection can overheat and cause terminal and/or terminal board failures. Examine the connection carefully for any signs of physical deterioration or loose fit to the motor terminal block. If there is evidence of deterioration or loose fit, remove the terminals from the lead wire then connect the lead wires directly to the motor terminal block wiring terminals. Care must be taken to assure connections are made to the proper terminals and adequate electrical clearances are maintained. ! NOTICE ! The motor and control are assembled as a set. There are no serviceable components in the motor or control. To prevent permanent damage to the unit, only apply nameplate voltage. Do not strike the motor shaft with a hammer or other tool as this may damage bearings. The IP45 rating is ensured when all conduits to the control are used and connected properly to incoming electrical power and digital lines, and
RkJQdWJsaXNoZXIy MTA3MzU=