Hog Slat Inc. Newton Grove, NC USA August 2019 19 Air Storm Fans For variable speed J5 Primary Jumper should be installed in the 60HZ position Ensure J1 Jumper is set to 10V If using a 0-10V control signal J5 Secondary Jumper should be in 2X position. If using a 10-0V control signal J5 Secondary Jumper should be in 1X position. The voltage control source should be wired into terminal block TB1 into the SIG and COM terminal as shown. A separate start and control should be wired into FWD and COM. If no separate start control signal is present then a jumper should be placed between FWD and COM.
RkJQdWJsaXNoZXIy MTA3MzU=