Hog Slat Inc. Newton Grove, NC USA August 2021 71 Grow-FlexTM Feed System Disconnect power to the system to prevent accidentally starting the system. 8. If the system must be disassembled, extreme caution must be used to prevent injury from springing auger. A. Disconnect power to the entire system. B. Pull the Anchor Bearing Assembly and approx.18” (45 cm) of auger out of the unloader. C. Place a clamp or locking pliers on the auger to prevent it from springing back into the auger tubes. D. Remove Anchor Bearing Assembly. E. Carefully release the clamp securing the auger. CAUTION: Stand clear...the auger will spring back into the tubes. F. Remove remaining system components in the opposite order they were installed, according to this manual
RkJQdWJsaXNoZXIy MTA3MzU=