Hog Slat Inc. Newton Grove, NC USA APRIL 2023 REV IR 3 Grow-FlexTM Feed System Installation: 1. Delay Relay Kit should be installed in a convenient location near the feed system “Power Drive Control Unit” or other equipment being connected. 2. Initial delay set-point should be set to approximately 30 seconds. 3. Further adjustment to the delay time may be necessary depending upon fill system set-up. Wiring: IMPORTANT ! Disconnect all electrical power before attempting installation of this (or any equipment), inspecting or servicing. Ground all electrical equipment in accordance with applicable codes. Do not assume equipment will automatically be grounded due to incidental metal-to-metal contact. ALL electrical wiring must be done by a qualified electrician in accordance with local and national electric codes. Maximum Ratings: 1 1/2 HP @ 230VAC, 50/60 Hz. TIME DELAY ADJUSTMENT .3 to 300 Seconds .3 1-100 SECONDS HS1147 INSIDE VIEW
RkJQdWJsaXNoZXIy MTA3MzU=