Hog Slat Inc. Newton Grove, NC USA OCTOBER 2023 3 FEED SYSTEMS 9 605992 LOCK WASHER #6 27 HS597-2 COVER 10 60912 6-32 HEX MACHINE NUT 28 HSLABEL-317 PROP 65 WARNING LABEL 11 HSDTC01-14 SWITCH PIN 29 HSLABEL-008 LABEL,WARNING-SHOCK HAZARD (ENGLISH) 12 60916 6-32 X .375” TAPPING SCREW 30 1121010500 10-32 HEX NUT 13 HSDTC01-11 INSULATOR 31 HSLABEL-116 LABEL,WARNING-SHOCK HAZARD (FRENCH) 14 HSLABEL-364 LABEL, HOPPER LEVEL CONTROL, HS1155 32 61655 6-20 X 3/8" TAPPING SCREW Type BT 15 HSDTC01-08 BOX ENCLOSURE 33 HS1155-6 ADJUSTMENT BRACKET STANDOFF 16 HSPT-004 PIGTAIL- SJ 14/2 X 36" 34 60913 6 - 32 X 1", MACHINE SCREW 17 61646 LIQUID TIGHT CONNECTOR 1/2" 35 HS1155-7 SLIDE HEIGHT ADJUSTMENT BRACKET 18 HS597-1 SWITCH COVER PLATE Installation: The HS1155 Hopper Level Control should be installed in the last hopper or feeder which is located at the end of the delivery or fill system. The unit should be mounted low in the hopper or feeder so the fill level in the control hopper will be lower than the others. This will cause the fill system to cycle more frequently insuring a proper feed level in every hopper or feeder. It will also provide a reservoir of feed in the system if another control hopper calls for feed. The feed drop tube should be positioned so that feed is delivered to the center and near the top of the control in front of paddle. Drop tubes and other control units should be positioned high in other hoppers or feeders so that they will fill but not overflow. 1. (Figure 1) Illustrates a typical installation example of the HS1155 into a metal style feed hopper. 2. (Figure 2) Illustrates a typical installation example into a plastic style feed hopper 3. Hopper Level Control is held in place by pinch bolt on outside surface. 4. Loosen the two wing nuts on top to slide the switch assembly until in hangs straight vertically, retighten wing nuts. The HS1155 must be mounted vertically to ensure the proper movement of the switch and paddle.
RkJQdWJsaXNoZXIy MTA3MzU=