Hog Slat Inc. Newton Grove, NC USA OCTOBER 2023 5 FEED SYSTEMS 5. Feed height can be adjusted by loosening two wings nuts and sliding switch assembly up or down the adjustment bracket for desired feed level. Refer to Figure 3. Figure 3 Lowest Setting Highest Setting 6. The front feed shield cover can be removed depending upon application requirements. Simply loosen the four screws approximately 2 turns and slide feed shield up so that screw heads align with large opening in key slots. Pull field shield over screw heads and remove. Replacement of feed shield is performed in reverse order. Figure 4 Wing Nuts Loosen screws on both sides approx. 2 turns Slide feed shield upward
RkJQdWJsaXNoZXIy MTA3MzU=