GrowerSELECT - HS569A Poultry Feed Line Hopper Assembly Installation Manual

Hog Slat Inc. Newton Grove, NC USA March 2019 6 Feed Line Hoppers Assembly: 1. Assemble (4) Side Sheet Hopper Panels (Ref# 1) as shown above in Figures 1 and 2 using Hex Bolts 1/4-20 X 0.5” (Ref# 15) and Hex Flange Nuts 1/4-20 (Ref# 13). Hand Tighten 2. Attach (4) Boot Hanger Brackets (Ref# 2) to the outside of the hopper body as shown above in Figures 1 and 2 using Hex Bolts 1/4-20 X 0.5” (60500) and Hex Flange Nuts 1/4-20 (60577). Hand Tighten 3. Attach (2) Cable Guide Brackets (Ref# 5) to outside of hopper body as shown above in Figures 1 and 2 using Hex Bolts 5/16-18 X 0.75” (60508) and Hex Flange Nuts 5/16-18 (60624). Hand Tighten 4. Attach Top Brace (Ref# 4) to outside of hopper body as shown above in Figures 1 and 2 using Hex bolts 5/16-18 X 0.75” (60508) and Hex Flange Nuts 5/16-18 (60624). Hand Tighten 5. Loosely assemble (2) Suspension Brackets (Ref# 6) around the unloader as shown below. Be sure to configure the orientation you want in this step. For the 200# and 300# hoppers also install the “S” braces (HS569-49) in addition to the cross member braces (HS569A-10) as shown in Figure 3b. Figure 3a is for the 120# hopper and Figure 3b is for the 200# and 300# hoppers. Use hex bolts 5/16-18 X 0.75” (60508) and hex Flange Nuts 5/16-18 (60624). Figure 3a Figure 3b 6. Attach (4) Hopper Adjustment Brackets (Ref# 3) as shown above in Figures 1 and 2 using Hex bolts 5/16-18 X 0.75” (60508) and Hex Flange Nuts 5/16-18 (60624). Hand Tighten. 7. Suspend Lower Assembly using Clevis Pins (2) (Ref# 11) and Cotter Hairpins (2) (Ref# 10) from feed system support cables. 8. Slide bottom of hopper body into upper channel of the Unloader and secure with Cotter Pin (60699) as shown above in Figures 1 and 2. 9. Redirect suspension cables to travel through Cable guide bracket to provide lateral support. 10. Attach Hose Clamp (Ref# 7) to Top Brace (Ref# 4) using 1/4-20 X 1.5” Machine Screw (616510), Hex Flange Nuts 1/4-20 (60577), and Chain (Ref# 8).