Hog Slat Inc. Newton Grove, NC USA JUL 2019 REV A5 3 Ventilation System 8. Route cable outside of load block area before exiting the machine. Openings are available to route cables away to provide clearance for the Load block travel. 9. Exit points can be through side of the machine (as circled below) or route cable to bottom of machine and exit through bottom plate. 10. (1) Liquid tight connector is provided for exiting the machine housing. If used, drill 7/8” ID hole through cabinet wall and install liquid tight connector. 11. Protect cable/wires from metal edges by adding protective covering over wire to prevent wire damage. Electrical Rating: Contact voltage AC MAX: 240 VAC Contact current AC MAX: 3 A Contact form: Normally Open and Normally closed single action
RkJQdWJsaXNoZXIy MTA3MzU=