Hog Slat Inc. Newton Grove, NC USA February 2019 12 Ventilation System L. Tighten set-screws in upper flange bearing. M. Verify drive screw rotates freely and is not binding at the plastic collar. If it is too tight, loosen set screw in plastic collar and repeat step J. N. Replace drive motor per instructions found in Section 1.2: "Installation of Drive Motor" O. Apply line of Lithium NLGI Grade 2 grease to length of drive screw. P. Re-apply tension to cables/chain in machine. Q. Re-connect power.
RkJQdWJsaXNoZXIy MTA3MzU=