Hog Slat Inc. Newton Grove, NC USA February 2019 7 Ventilation System B. Disconnect power from machine. C. Remove tension on cables/chains that are connected to the load block assembly. D. Remove drive motor per instructions in Section 1: " Drive Motor Replacement". E. Remove snap ring from load nut which is located on motor side of the load block assembly. It is not necessary to take care to save the snap ring unless it is to be re-used. A new snap ring is provided with the replacement load nut kit HS583-8-2A. F. Loosen set-screws on upper flange bearing with 1/8” Allen wrench.
RkJQdWJsaXNoZXIy MTA3MzU=