GrowerSELECT - HS583E Enclosed Curtain Machine Service Manual

A. Disconnect power to machine.	4
C. Refer to section 9.1 : "Removal of Limit Switch Enclosure". Steps 9.1-A thru 9.1-G	4
B. Install jaw coupling onto motor shaft along with key provided with motor.	5
C. Slide coupling onto shaft until shaft end of motor is flush to 1/8" protruding from coupling.	5
B. Disconnect power from machine.	7
D. Remove drive motor per instructions in Section 1: " Drive Motor Replacement".	7
E. Remove snap ring from load nut which is located on motor side of the load block assembly. It is not necessary to take care to save the snap ring unless it is to be re-used. A new snap ring is provided with the replacement load nut kit HS583-8-2A.	7
A. Remove drive screw. Refer to Section 5.1: "Removal of Drive Screw"	13
A. Refer to Section 2.1: "Removal of Load Nut"	14
E. Remove (2) retaining bolts securing the flange bearing into the machine housing. Using 1/2" wrench or socket.	14

RkJQdWJsaXNoZXIy MTA3MzU=