Hog Slat Inc. Newton Grove, NC USA March 2021 Rev A2 2 Grow-Flex™ Feed Systems Overview: The GrowerSELECT HS589CR Feed Line Control Unit Switch Assembly Kit is designed to replace broken and obsolete switches that are part of control units for flexible auger feed systems. This switch is used to control the auger drive motor by turning off the power when feed is present and turning on the power when feed has been removed from the control unit housing. It is a direct replacement for the Chore-Time 6655R Switch Assembly used in the 6560 Control Unit and the 8789 Switch Assembly used in the 24482 Control Unit. If necessary, the diaphragm used in the corresponding Control Unit can be purchased separately. Diaphragms Sold Separately: The HS582CRL Large Diaphragm is used in the 6560 Control Unit assembly. The HS582 Small Diaphragm is used in the 24482 Control Unit assembly. The sensitivity of the electrical switch is not adjustable. Contents of the HS589CR KIT: Quantity Name 1 Switch Assembly Enclosure 1 HS589-8 Mounting Plate 1 HS589CR-2 Seal 4 10-32 Hex Nuts 4 ¼-20 Hex Nuts 4 10-32 Lock Nuts 4 #10 Washers MAXIMUM LOAD RATING: 1 ½ HP @ 230VAC A red indicator light on the side of the switch housing will illuminate when the diaphragm has been pressed (MOTOR OFF) and the switch has been activated. The ON/OFF switch is used to enable or disable the Control Unit. DO NOT USE THIS SWITCH AS DISCONNECTING MEANS FOR SERVICING.
RkJQdWJsaXNoZXIy MTA3MzU=