Hog Slat Inc. Newton Grove, NC USA April 2023 REV IR 2 Grow-Flex™ Feed Systems Screw torque tightening requirement for enclosure box is 15 in-lbs and terminal strip is 7.5 in-lbs. The ON/OFF switch is used to enable or disable the Control Unit. DO NOT USE THIS SWITCH AS DISCONNECTING MEANS FOR SERVICING. HS589T Feed Line Control Unit Switch Assembly REF # PART # DESCRIPTION REF # PART # DESCRIPTION 1 HS582 DIAPHRAGM 17 SWITCH MOUNT 2 HS589-8 ASSY-PLATE, MOUNT CONTROL BOX 18 FILM, INSULATION SWITCH 3 NUT HEX MACHINE SCREW #10-32 19 EL1052M SWITCH, SNAPACTION 20A @ 250VAC 4 HS529-45 PLUNGER SEAL 20 NUT HEX MACHINE SCREW #6-32 5 LOCKNUT NYLON INSERT #10-32 21 HS589-3 GASKET, COVER SWITCH HOUSING 6 HS589-1 BOX, SWITCH HOUSING HS589 22 HS589-2 COVER, SWITCH HOUSING 7 EL1011 SWITCH, TOGGLE DPST, 20A @ 250V, 2HP 23 SHOULDER SCREW 10-16 X 1.375” HEX HEAD 8 EL1082 PLATE, LEGEND, VERTICAL ON-OFF 24 HS689-6 BRACKET, TERMINAL STRIP 9 EL1083 SWITCH BOOT 25 SCREW. PHILLIPS, 6-32 X 0.25” 10 EL1079 LIGHT, INDICATOR NEON RED 26 NUT HEX MACHINE SCREW #6-32 11 SCREW PHILLIPS - TYPE BT #6-20 x .375” 27 EL1267 TIME DELAY, 3-300 SECONDS, 30 AMPS 12 HS589-4 COMPONENT MOUNT PLATE 28 FLAT WASHER, #6 ZINC 13 SCREW PHILLIPS PAN HEAD #6-32- X 1” 29 SCREW #6-32 X 1" PHILLIPS PAN HEAD 14 HS589-6 SWITCH PIN, PLUNGER 15 EL1086 TERMINAL STRIP 6 POSITION 10 AWG MAX 16 SCREW PHILLIPS TYPE #6-32 X 1" Installation: 1. (Figure 1) Illustrates a typical installation example of the HS589T control unit switch assembly to a HS593 or other OEM Control Units. FIGURE 1 Safety Decal HSLABEL-008 &116 “Warning Shock Hazard”
RkJQdWJsaXNoZXIy MTA3MzU=