Hog Slat Inc. Newton Grove, NC USA June 2020 2 Grow-FlexTM Feed System Installation: 1. Determine the desired location for the Outlet Drop. Drill or cut the desired outlet hold based on system requirement of Standard Outlet or Total Drop-Out Outlet. Reference Figures and Charts below. Model Item 1 Item 2 55/220 1-1/2" Dia (38 mm) 3" (76 mm) 60/237 1-3/8” Dia (35mm) n/a 75/300 2 1/2" Dia (63 mm) 5" (127 mm) 90/350 3" Dia (76 mm) 6" (152 mm) Special Notes for Chain Disk Drops Only: Use a hole saw or uni-bit (step drill) to drill outlet holes. All burrs should be removed after cutting so drop will perform properly. This is especially important when installing on metal tubing for chain disk systems as to not damage the chain or drop adaptor. If Drop Tube Housing is installed at an angle to the right as shown below, insert Shutoff (Item 3 in Figure 1) as shown below with long side on the left. Drop Tube Housing Shutoff
RkJQdWJsaXNoZXIy MTA3MzU=