GrowerSELECT - HS610 Aqua Bowl Watering System Installation Manual

HS610 AQUABOWL AND HS610-1 AQUAFLO NIPPLE ASSEMBLY · Page 2 . 1. Position HS610 AquaBowl in front corner of crate. Either left or right (shown) Position so that slots in AquaBowl align with slots in flooring. See Figure 1 2. Position HS610-1 water pipe/nipple assembly along crate sides so that water nipple is presented to sow as shown. Attached HS610-1 water pipe/nipple assembly using appropriate sized U- Bolt and plate to fit crate pipe size. See figure 2 3. HS610 bowl may be fastened to floor using Cap head bolt and fender washer or Smart Floor Fastener (if only top access is available). (see table “Floor Fasteners”) (3 fasteners/bowl minimum) Four slots are available in the AquaBowl for up to (4) fasteners Figure 1 Figure 2 Figure 3 U-Bolt and Back plate Suggested location of floor fasteners if only (3) are used. Position water nipple so it is just below top edge of the bowl.