GrowerSELECT - HS615 Time Delay Relay 240V Coil Installation Manual

Hog Slat Inc. Newton Grove, NC USA November 2018 1 Grow-Flex TM Feed System HS615 TIME DELAY RELAY-240V COIL (Includes Spanish Version - Incluye versión en español) General Installation Notes: Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Unless otherwise specified, all Feed Delivery Systems (Diameters) are installed similarly. Note: Delay Relay Kit is to be wired in accordance with all local, state and national wiring codes. All wiring sizes and fuse capacities are to be sized according to national electrical code specifications or other applicable regulations. Safety Instructions: Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Ground all electrical equipment for safety. Ground all non-current carrying metal parts to guard against electrical shock. Always keep safety decals in good condition and replace missing or damaged decals. Overview: The Time Delay Relay assembly is designed to provide a “Start up delay” to prevent the fill system auger drive motor from short cycling. Short cycling of the auger drive motor can result in premature failure. The Time Delay Relay connects between the Control Unit and the Auger Motor. Once the signal from the Control Unit switches from “Motor OFF” to “Motor ON”, the delay timer starts counting down from the set time delay. At the end of the time delay, Auger Motor operation resumes.