Hog Slat Inc. Newton Grove, NC USA JUNE 2020 REV A5 3 Delay Timer Installation: 1. Delay Relay Kit should be installed in a convenient location near the feed system “Power Drive Control Unit” or other equipment being connected. 2. Initial delay set-point should be set to approximately 15 seconds. 3. Further adjustment to the delay time may be necessary depending upon fill system set-up. Wiring: IMPORTANT Disconnect all electrical power before attempting installation of this (or any equipment), inspecting or servicing. Ground all electrical equipment in accordance with applicable codes. Do not assume equipment will automatically be grounded due to incidental metal-to-metal contact. ALL electrical wiring must be done by a qualified electrician in accordance with local and national electric codes. MAXIMUM RATINGS: 1 AMP CONTINUOUS DANGER: Electrical Hazard HS689 / HS693 Control Unit HS617
RkJQdWJsaXNoZXIy MTA3MzU=