GrowerSELECT HS676 Control Unit For HSSD-CU Sow Drop Installation/Opperation manual

Hog Slat Inc. Newton Grove, NC USA July 2019 1 Feed Systems HS676 Control Unit for HSSD-CU – 230V Single Phase (Includes Spanish Version - Incluye versión en español) (Includes French Version - Comprend la version française) General Installation Notes: Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Unless otherwise specified, all Feed Delivery Systems (Diameters) are installed similarly. Note: Control Unit Switch Assembly is to be wired in accordance with all applicable local and national electrical wiring codes. All wiring sizes and fuse capacities are to be sized according to applicable electrical code specifications or other regulations. Safety Instructions: Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Ground all electrical equipment for safety. Ground all non-current carrying metal parts to guard against electrical shock. Always keep safety decals in good condition and replace missing or damaged decals. Do not connect rigid conduit to the enclosure (box switch housing). Overview: The HS676 Sow Drop Control Unit is designed for use with a flexible auger and chain disk feed systems where control of an auger drive motor is required. Power to the auger drive motor is controlled by a built-in proximity feed sensor coupled to a relay to provide non-contact feed sensing with built-in adjustable start up delay. . ELECTRICAL RATING : 1 ½ HP @ 230VAC MAX, 1 PHASE The ON/OFF switch is used to enable or disable the Control Unit. DO NOT USE THIS SWITCH AS DISCONNECTING MEANS FOR SERVICING.