GrowerSELECT HS676 Control Unit For HSSD-CU Sow Drop Installation/Opperation manual

Hog Slat Inc. Newton Grove, NC USA July 2019 6 Feed Systems HS10 FEED SENSOR PROXIMITY SWITCH: Specifications: Operating Voltage: 90-250 VAC Frequency: 50-60 Hz Relay Contact Maximum Current Load: 5A Resistive and 2A Inductive (Motors and Relays) Sensitivity: 0-9/16” (Factory Setting is for ¼”) Time Delay Range: 0-4 Hours (Factory Setting is for 30 seconds) Ambient Operating Temperature: -4°F-+158°F Cord: 18-5 SJTW Operating Instructions: All settings should be made with Product (Grain or Feed) not in contact with sensor (Sensor is not Activated). Figure 4 Setting Time Delay (Factory setting is 30 seconds) 1. Press Buttons “A” & “B” simultaneously twice (2) until Mode LED is Red 2. Press and Release Button A once for each minute of delay desired 3. Press and Release Button B once for each second of delay desired 4. To exit Time Delay Program Mode, Press Buttons “A” & “B” simultaneously once 5. Red Program Mode LED will go off Setting Sensitivity (Factory setting is ¼”, for grain) 1. Press Buttons “A” & “B” simultaneously once until Mode LED is Green 2. Press and Release Button A will decrease sensitivity by 1/32” 3. Press and Release Button B will increase sensitivity by 1/32” 4. To exit Time Delay Program Mode, Press Buttons “A” & “B” simultaneously twice (2) 5. Green Program Mode LED will turn Red then go off. Setting Special Functions 1. Reset to Factory setting for Sensitivity and Delay  Press Button “A” & “B” simultaneously and hold for 15 seconds until both LEDs turn “yellow.” 2. Show Delay • Press and hold button “A” and then press button “B” twice (2). Mode LED will flash Red once for each minute of delay, flash Green once for each second of delay and flash Yellow once for each hour of delay. (For example: 1 Red flash and 2 Green flashes indicate 1 minute and 2 second delay) 3. Switch Off Delay  Press and hold Button “A” and then press Button “B” seven (7) times