Grow-Flex™ Feed Systems Hog Slat Inc. Newton Grove, NC USA May 2023 Rev IR 2 Screw torque tightening requirement for enclosure box is 15 in-lbs and terminal strip is 7 in-lbs. A red indicator light on the side of the switch housing will illuminate when the diaphragm has been pressed (MOTOR OFF) and the switch has been activated. The ON/OFF switch is used to enable or disable the Control Unit. DO NOT USE THIS SWITCH AS DISCONNECTING MEANS FOR SERVICING. HS689T Control Unit Switch Assembly REF # PART # DESCRIPTION REF # PART # DESCRIPTION 1 HS582 DIAPHRAGM ASSEMBLY 12 HS589-2 COVER, SWITCH HOUSING 2 HS589-8 ASSY-PLATE, MOUNT CONTROL BOX 13 HS589-3 GASKET 3 HS529-45 PLUNGER SEAL 14 HS689-6 BRACKET, TERMINAL MOUNT OFFSET 4 HS589-1 BOX, SWITCH HOUSING 15 EL1052M SNAP ACTION 20A @ 250VAC SWITCH 5 HS589-4 COMPONENT MOUNT PLATE 16 HS589-5 SWITCH MOUNT 6 EL1081 RELAY BRACKET 17 HS589-6 SWITCH PIN 7 EL1080 RELAY, MULTIPOLE, NO 208-240V, 25A 18 HSLABEL-104 LABEL, LIQUID TIGHT CONNECTOR LOCATION 8 HS529-50 INSULATOR, SWITCH-MYLAR 19 EL1079 INDICATOR LAMP, RED, 250 VAC 9 EL1161 Terminal Strip 8 Position 10 AWG Max 20 EL1083 TOGGLE SWITCH BOOT COVER 10 HSLABEL-008 WARNING- SHOCK HAZARD DECAL 21 EL1082 LEGEND PLATE 11 60932 Screw #10-16 x 1-1/4" SS 22 EL1011 SWITCH, TOGGLE DPST, 20A @ 250V, 1 ½ HP 23 EL1088 TIME DELAY, 1 – 100 SECONDS
RkJQdWJsaXNoZXIy MTA3MzU=