GrowerSELECT - HS730 Series Stage Manager Controllers Installation Manual

Hog Slat Inc. Newton Grove, NC USA August 2017 1 Ventilation Systems HS730 SERIES STAGE MANAGER CONTROLLER General Installation Notes: Make sure that power is disconnected from system prior to servicing. Installation of this equipment and related OEM equipment should be in accordance with these instructions, OEM’s installation instructions and local codes (if applicable). Failure to follow specified instructions may cause damage to equipment and/or personal injury or death. Take special note of any Warnings or Safety Decals on the equipment and in manuals. Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear Plugs) when working with the equipment. Discarded materials, equipment and boxes should be recycled in accordance with local and national codes. Note: Assembly is to be wired in accordance with all applicable local and national electrical wiring codes. All wiring sizes and fuse capacities are to be sized according to applicable electrical code specifications or other regulations. Safety Instructions: Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and safe operating practices. Ground all electrical equipment for safety. Ground all non-current carrying metal parts to guard against electrical shock. Always keep safety decals in good condition and replace missing or damaged decals. Overview: The HS730 SERIES Stage Manager Controller provides intermediate control between an environmental control system and accessories such as fans, pumps, heaters etc… With each accessory connected to individual stages within the Stage Manager, the operator is able to manually operate the accessories ON or OFF independent of the environmental controller. The HS730 Stage Manager relay cards provide isolation between the control signal and the load or accessory, allowing a 120VAC control signal to operate a 240VAC motor as example. Stage switch controls are located on the front panel with control signal indicator and write on labels to fully customize controller layout and stage identification. ELECTRICAL RATING : Relay PCB Control Control Signal: 120VAC @ 60Hz, single phase. Output: Relay DPST, Contact maximum rating 15 Amp, 2HP @ 240VAC Switch Control DPDT Toggle switch Maximum Ratings: 15A @ 250 / 277VAC 1 ½ HP @ 125 VAC 2 HP @ 250 VAC