GrowerSELECT - HS730 Series Stage Manager Controllers Installation Manual

Hog Slat Inc. Newton Grove, NC USA August 2017 3 Ventilation Systems Installation: 1. Install mounting hardware using mounting tabs and screws provided onto back of enclosure as shown. 2. Determine appropriate mounting location near environmental controller or controlled equipment. Location should provide adequate ventilation and safe and easy access to front panel. Mounting height should be near eye level to aid in the visibility of the control indicators. Location should be such to avoid wash down spray. 3. All wire conduits should enter from the bottom of the enclosure. Use only liquid tight connectors or PVC conduit to maintain seal. Wiring Instructions: PCB RELAY CARD (HS730R) Figure 1 ALL CONNECTIONS TO PCB RELAY CARDS ARE PREWIRED TO TERMINAL BLOCKS FOUND INSIDE ENCLOSURE. FIGURE 1 ILLUSTRATES HOW PCB RELAY CARDS ARE CONNECTED.