Hog Slat Inc. Newton Grove, NC USA February 2022 2 Grow-Flex™ Feed System Installation: 1. (Figure 1) Illustrates a typical installation example of the HS782 Feed Level Control unit to a HS593 or other OEM Control Units. FIGURE 1 2. See instructions for external wiring for single phase operation. 3. When connecting wire from equipment to terminal strip, remove no more than ¼” of insulation from end of wire. Be sure there are no stray wire strands before inserting wire into terminal strip. Insert wire into terminal ¼” and tighten terminal strip set screw. 4. Care should be taken when drilling pilot holes to prevent damage to wires or other components. WIRING INSTRUCTIONS FOR HS593
RkJQdWJsaXNoZXIy MTA3MzU=