GrowerSELECT - HSAB75 Anchor Bearing Installation Manual

Hog Slat Inc. Newton Grove, NC USA September 2018 2 Anchor Bearings Installation: The HSAB75 is intended to be used with Model 75 feed auger systems. Extreme caution must be taken when attaching auger. Always use locking pliers when assembling. Carefully insert the auger through the unloader as shown in Figure 1. Tighten locking pliers onto auger (inside of unloader) to hold auger in place while assembling to anchor bearing. Insert the anchor bearing into the auger until the auger touches the anchor bearing flange. The auger must be threaded onto the auger clamp pin. Tighten the clamp pin set screw on the auger. Do not over tighten as auger will deform and be unable to rotate freely. Remove locking pliers and attach anchor bearing into unloader with anchor bearing clamp. 1 Anchor Bearing Clamp 2 Anchor Bearing Assembly 3 Auger Clamp Pin 4 Auger 5 Unloader