Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System HSCC-1000/HSPK-JETLF LEVEL RITE Installation Information
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System WARNING! THE INCLUDED SOLENOID VALVES ARE NORMALLY CLOSED! POWER MUST BE REMOVED WHEN THE SYSTEM IS DRAINED OR WINTERIZED! IF THERE IS NO WATER PRESENT IN THE TROUGH POWER MUST BE REMOVED!
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System Level Rite Electronic Float Management System HSCC-1000, HSPK-JETLR 1. Determine installation position of incoming fill taking into account the following Incoming water supply should be closely located to the Assembly. If possible it is recommended to install float switches on the flush end cap. ! A DEDICATED POWER OUTLET IS REQUIRED FOR CORRECT OPERATION! THIS POWER OUTLET SHOULD REMAIN “ON” CONTINUOUSLY. THE FILL CONTROL SYSTEM SHOULD REMAIN POWERED ON ANYTIME THE SYSTEM HAS WATER IN IT. 1. Open the control box (HSCC-1000) and remove the float switch assemblies. Weatherproof wire nuts are included in the float switch boxes. 2. Mark location for float switch installation on either the flush end cap or the trough itself. See image below for dimensions. 3. Drill float switch mounting holes to 0.625” (5/8”) 4. Insert and secure float switches with retaining nut and rubber washer.
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System FLOAT SWITCH MUST BE INSTALLED SO THAT THE FLOAT TRAVELS UPWARD! SEE IMAGE BELOW! END CAP INSTALLATION TROUGH INSTALLATION 5. With door open mount Level Rite Assembly by attaching via 4 mounting holes shown below.
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System 6. Using supplied weatherproof wire nuts connect the High Float Switch (Switch installed at 3.50” Height) to shielded wire lead identified with the colored sticker (If sticker is missing wire can be identified as the wire coming out of the top small liquid tight in the drawing below) Orientation is non critical. 7. Using supplied weatherproof wire nuts connect the Low Float switch to the other shield wire exiting though the lower liquid tight. 8. Install the inlet bulkhead fitting and plumbing connections. A 5 foot hose is supplied with the Level rite float kit. Additional hose can be ordered and installed if a more remote location is required. 9.
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System END CAP INSTALLATION TROUGH INSTALLATION See below for general routing diagram
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System IN THE EVENT OF AN ELECTRICAL FAILURE OR OTHER UNFORSEEN ISSUES THE MANUAL BALL VALVE CAN BE OPENED AS A BYPASS TO ALLOW WATER TO ENTER THE SYSTEM!
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System Level Rite (HSCC-1000) Replacement Part List
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System WINTERIZATION LEVEL RITE Systems must be winterized prior to first freeze similar to exposed backflow prevention devices. ! POWER MUST BE REOMVED FROM THE UNIT TO WINTERIZE AND ANYTIME WATER IS NOT PRESENT IN THE TROUGH. POWER SHOULD NOT BE REAPPLIED TO UNIT UNTIL THE FOLLOWING SPRING OR UNTIL THE EVAP SYSTEM RETURNS TO SERVICE!
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System Hog Slat Limited Warranty Hog Slat warrants products to be free from defects in material or workmanship for a period of twenty-four (24) months from the date of original purchase. Hog Slat will credit, repair, or replace, at its option any product deemed defective within this time period. Labor costs associated with the replacement or repair of the product are not covered by the Seller/Manufacturer. Warranty Extension Coverage The Limited Warranty period is extended for the following products: Cool Cell System 5 Years (Less Pads and Pumps) Conditions and Limitations 1. The product must be installed by and operated in accordance with the instructions published by the Seller/Manufacturer or Warranty will be void. 2. Warranty is void if all components are not original equipment supplied by the Seller/Manufacturer. 3. This product must be purchased from and installed by an authorized retailer/distributor or certified representative thereof or the Warranty will be void. 4. Malfunctions or failure resulting from misuse, abuse, negligence, alteration, accident, or lack of proper maintenance shall not be considered defects under the Warranty. 5. This Warranty applies only to components/systems for the care of poultry and livestock. Other applications in industry or commerce are not covered by this Warranty. 6. This Warranty applies only to the Original Purchaser of the product. The Seller/Manufacturer shall not be liable for any Consequential or Special Damage which any purchaser may suffer or claim to suffer as a result of any defect in the product. “Consequential” or “Special Damages” as used herein include, but are not limited to, lost or damaged products or goods, costs of transportation, lost sales, lost orders, lost income, increased overhead, labor and incidental costs and operational inefficiencies. THIS WARRANTY CONSTITUTES THE SELLER/MANUFACTURER’S ENTIRE AND SOLE WARRANTY AND THIS MANUFACTURER EXPRESSLY DISCLAIMS ANY AND ALL OTHER WARRANTIES, INCLUDING, BUT NOT LIMITED TO, EXPRESS AND IMPLIED WARRANTIES AS TO MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSES SOLD AND DESCRIPTION OR QUALITY OF THE PRODUCT FURNISHED HEREUNDER. Hog Slat Retailers/Distributors are not authorized to modify or extend the terms and conditions of this Warranty in any manner or to offer or grant any other warranties for Hog Slat products in addition to those terms expressly stated above. An officer of Hog Slat must authorize any exceptions to this Warranty in writing. The Seller/Manufacturer reserves the right to change models and specifications at any time without notice or obligation to improve previous models.
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System THIS PAGE INTENTIONALLY LEFT BLANK
Hog Slat Inc. Newton Grove, NC USA August 2019 Evaporative Cooling System This equipment must be installed in accordance with all State and Local Codes and applicable Regulations which should be followed in all cases. Authorities having jurisdiction should be consulted before installations are made. Hog Slat, Inc. PO Box 300 Newton Grove, NC 28366 Phone: (910) 594-0219 Fax: (910) 594-1392 www.hogslat.com Copyright © 2019 by Hog Slat, Inc. Part Number: HSMANUAL210 Rev A1 Market - Hog & Poultry Product Group: Grower Select
hogslat.comRkJQdWJsaXNoZXIy MTA3MzU=