Hog Slat Inc. Newton Grove, NC USA May 2020 REV A8 23 GROW-DISK™ Feed System START button will change to gray color while the STOP button will turn red, indicating program is running. Display will update and show status of feed cycle (when the cycle is to start, next dump cycle etc…) To stop the feed cycle regardless of which mode has been selected, press the red STOP button. This will end the cycle and not restart until the START button is pressed. 10.SYSTEM FAULTS: There are six (6) conditions that can result in a fault and stop the controller. When the controller is in “FAULT”, the feed cycle will not restart until the fault is cleared. ALARM output is active as well as the TROUBLE LIGHT output. The HOME page STATUS Line shows the type of fault that has occurred. Press the RED RESET button found at the bottom right of the page to reset and acknowledge the fault once the condition has been corrected. After pressing the RESET button, a new page will appear to acknowledge the type of fault. Press ACKNOWLEDGE button to reset the fault / Alarm.
RkJQdWJsaXNoZXIy MTA3MzU=