Hog Slat Inc. Newton Grove, NC USA May 2020 REV A8 26 GROW-DISK™ Feed System 14. BATTERY BACK UP: Controller has an onboard battery used to retain memory in case of short term or long term power loss. If battery was to need replacing, use only CR2032. 15. SOFTWARE UPDATE: In the event it becomes necessary to update the microprocessor software, it can be updated via the data port. Remove power from the controller. Access the data port located on the back of the front door near the top. Insert flash drive containing software update. Return power to controller. Update should start automatically. Screen visible should show V1.5 with an increasing numeric value beside it indicating the status of the update. Once the update completes the display will indicate to remove the flash drive. In the event the automatic update does not start on power up, remove power and start process once again. Touchscreen display can also be updated. This information contains all of the on-screen information and touch panel configuration. Remove power from the controller. Open front door and locate back of touchscreen. Use the SD card containing software update. Insert card into SD slot location on the touchscreen PCB on the left hand side. Insert SD card until it clicks into place. Restore power to controller. Automatic update will occur. When complete, screen will switch to HOG SLAT LOGO screen. In most cases controller will resume operation from this screen, If not touch screen twice which will advance screen to the HOME screen. UPDATE is complete. Remove power and remove SD card by pushing in the card to release it. 16. REPLACEMENT PARTS: ITEM NUMBER PART NUMBER DESCRIPTION 1 HSCD200-2 CIRCUIT BOARD, MAIN PRE-PROGRAMMED 2 EL1223 PLUGGABLE, THREE POSITION CONNECTOR 5.08mm 3 EL1224 PLUGGABLE, TWO POSITION CONNECTOR 5.08mm 4 EL1225 2 POLE CONTACTOR, 230V COIL 5 HSCD200-3 7” TOUCH SCREEN, PRE-PROGRAMMED 6 HSCD200-1-8 HINGE ASSEMBLY 7 HSCD200-1-6 BOLT, PLASTIC FOR DOOR 8 HSCD200-5 FLASH DRIVE (NOT SHOWN) 9 HSCD200-1-7 GASKET, TOUCH SCREEN 10 HSCD200-1-10 CLEAR COVER, TOUCH SCREEN 11 HSCD200-1-11 LATCH, CLEAR COVER HSCD200-1-10A CLEAR COVER KIT – INCLUDES COVER, HINGES, LATCH AND HARDWARE 12 EL1051 FUSE 1.0 AMP 5 X 20MM FAST ACTING CARTRIDGE (5 PACK) 12
RkJQdWJsaXNoZXIy MTA3MzU=