Hog Slat Inc. Newton Grove, NC USA March 2022 16 Evaporative Cooling System Important The supplied tube of PVC Cement (Weld·On® 719™) is a special Extra Heavy Bodied Slow Setting PVC Plastic Cement and is the only adhesive that should be used to assemble cooling system trough components together. It is a solvent based adhesive designed especially for gluing PVC components together. The substitution of other adhesives and/or silicon, acrylic, etc. (painter’s type) caulks will result in leakage over time. They are sealants and not adhesives. The supplied cement should be sufficient to glue applicable components but if additional cement is required; it can be obtained at any Hog Slat retail outlet under part number HSES-34. End Panel Assembly Instructions 1. Using methods in section shown above, insert cement and place final Splice on the end of the trough as shown below in Figure 15. 2. Cut 2”X4” Cap to appropriate length according to Table F above. 3. Using screws (80509), toenail 2”x4” Cap into the rough opening ensuring it mounts flush to Trough End with Nipple and in the middle of the last Trough Splice as shown below in Figure 15. 4. Again using supplied screws (80509),fasten End Panels to 2”X4” Cap as shown below. Fasteners should be inserted through the holes in the side of the End Panel. Figure 15
RkJQdWJsaXNoZXIy MTA3MzU=