Hog Slat Inc. Newton Grove, NC USA March 2018 11 Ventilation Systems Step 7: Run a 1/8 inch diameter stainless steel rod (HS17111 or HS17112) through the center holes of the line of inlets. The rod should pass through both of the eye bolts in each inlet. Step 8: Attach the rod (HS17111 or HS17112) to the cable that runs to the actuator and winch system. Bend the end of the rod to form a loop. Clamp the loop tightly using two 1/8 inch cable clamps (617321). Pull the cable through the loop and clamp the cable using an appropriately sized cable clamps. Route the other end of the cable to the actuation system. Cable and Rod Connection (Figure 10) The rod can also be clamped directly to a pulley going to the actuator in some cases if the rod, actuation system, and pulley are in direct alignment with each other. Pulley and Rod Connection (Figure 11) Rod through Inlets (Figure 9)
RkJQdWJsaXNoZXIy MTA3MzU=