Hog Slat Inc. Newton Grove, NC USA August 2021 Installation BEARING SET SCREWS ARE SHIPPED LOOSE; THEY MUST BE TIGHTNED PRIOR TO OPERATION (SEEE STEP 9!) 1. Remove Prop from shaft taking special attention to retain spring pin or prop set screws. If spring pin is lost or prop is damaged replacement parts can be found and are called out in this manual. 2. Remove pulley from prop and retain for later use. New shaft keys are supplied with bearing conversion kits. a. For HSSCK-200A and HSSCK-200B remove split taper bushing from pulley as well and discard or retain for use on alternate fan. It should be noted that HSSCK-200A and HSSCK-200B conversion kits come with a shaft with a 1.00 Inch diameter on the pulley side. Correct Split taper bushing is provided with the kit to reuse OEM pulley, HOWEVER moving forward 1.00 Inch bore pulleys may be used as replacement PROVIDED PULLEY OD REMAINS THE SAME! IF PULLEYS CAN NOT BE REMOVED FROM SHAFT CONTACT YOUR LOCAL HOGSLAT/GEORGIA POULTRY STORE FOR REPLACEMENT INFORMATION. 3. Remove shaft assembly from uprights and discard. It may be beneficial to mark holes utilized for mounting for reference later in assembly. New mounting fasters are provided with the shaft conversion kits
RkJQdWJsaXNoZXIy MTA3MzU=