Hog Slat Inc. Newton Grove, NC USA August 2021 5. Attach bearing assembly to uprights as shown below paying special attention to orientation as called out in image. Secure mounting fasteners completely. IF 2 SETS OF MOUNTING HOLES ARE PRESENT ON BEARING ASSEMBLY THE TOP MOST SET SHOULD BE UTILIZED! 6. Attach prop to shaft and secure with either spring pin or set screws. Ensure prop attached is completely secured. Check for prop alignment at this time. Remove shims if necessary and once prop is centered vertically and horizontally tighten hardware securing bearings completely.
RkJQdWJsaXNoZXIy MTA3MzU=