Hog Slat Inc. Newton Grove, NC USA August 2021 7. Attach pulley and split taper bushing to keyed end of the shaft as shown in the image below. Secure split taper bushing hardware. BE SURE TO TIGHTEN SET SCREW ON SPLIT TAPER BUSHING. Shaft should be flush with split taper bushing. 8. Align pulley with tension arm and motor pulley by moving the shaft forward or backward in the bearings. HS783 is a laser alignment aid that can be purchased from your local Hog Slat/Georgia Poultry Store. DRIVE COMPONENTS ALIGNMENT o Proper alignment of pulleys, tension arms, etc... Is required to avoid excessive belt and drive component wear. Failure to maintain correct alignment during maintenance will void warranty of drive components A straight edge or laser alignment device should be utilized to check for alignment of drive components 9. Once pulleys are properly aligned SECURE BEARING SET SCREWS! This completes installation
RkJQdWJsaXNoZXIy MTA3MzU=