GrowerSELECT - HST1733 Turkey Feeder Adjustment Winch Kit Instruction Manual

Hog Slat Inc. Newton Grove, NC USA May 2018 3 Turkey Floor Feeding Systems 4. Route Cable under pulley on Insulator Bracket, under Winch Center Hub, up through clamp and back down through other side of clamp. Cable should be wrapped on same side of Winch Center Hub as cable first threaded through bracket, then under Winch Center Hub. 5. Wrap Cable once around Winch Center Hub. (Clockwise in Figure 6, below) 6. Route Cable under second Insulator Bracket pulley and feed Cable through the slots on top of Feeder Support Cones and under Tube Clamp bolts on other end of Feed Line. 7. Install second 10” Long Spring to Tube Clamp on other end of Feed Line and connect Cable to Spring with Cable Clamp same as other end. 8. Turn Winch handle to pretension Winch System so there is 1” (25mm) stretch on each 10” Springs. Assembling Feeder Lift Cables: 1. Install Lift Cables to each Feed Level Ring so that the Cable Stop is on outside of Feed Level Ring with Cable on inside of Feed level Ring (Figure 7) . Feed Level Ring should be positioned in third hole from bottom for most adult turkey applications. Figure 6 Figure 7