GrowerSELECT - HSWD Series Fan Wind Diverters Installation Manual
Hog Slat Inc. Newton Grove, NC USA April 2019 5 Wind Diverters Installation **NOTE: Installation of 14”, 18”, 24”, and 36” Wind Diverter kits are largely the same. Step 1: Unplug fan motor to prevent accidental operation during the installation of the wind diverter. Step 2: Using a ¼” drill bit, drill out the three pre-punched locations on the sloped surface of the cone. Step 3: Using the included hardware use one machine screw, one nylon lock nut, and two washers to fasten the brackets to the cone. See Figure 2 for the correct fastening order. Figure 1: Wind Diverter Properly Installed on Fan Housing.
Made with FlippingBook
RkJQdWJsaXNoZXIy MTA3MzU=