Hog Slat Inc. Newton Grove, NC USA February 2019 4 Wind Storm Fans 3. Remove old butterfly assembly from cone assembly. ! Be sure to keep cone assembly intact and it will be reused! 4. Remove butterfly from packaging, ensure outside circumference is free of dirt, oil, or debris. Apply adhesive weather stripping to entire surface between all mounting holes. Finally remove adhesive backing. 5. Insert butterfly into cone allowing the door to open towards the ground. ! Some cone assemblies have drain tabs located on the bottom panel, if this is the case orientation of the butterfly and cone assembly must match! See image for butterfly orientation! Pull butterfly until 4 mounting holes align with slots on cone. Be careful to keep installed weather stripping in place during installation. Insert hex bolts from inside the butterfly protruding through the cone (Holes in the butterfly are threaded to help with assembly)
RkJQdWJsaXNoZXIy MTA3MzU=