Hog Slat Inc. Newton Grove, NC USA June 2020 7 Air Storm Fans Assembly 1. Cut a 22” X 30” opening in the outermost surface of the pump out enclosure. If the enclosure is concrete construct a frame of weather resistant material. 2. Wire motor following steps provided in the wiring section of the manual. 3. Secure pit transition with fasteners (not provided) to the frame of outer surface. 4. Close any remaining air gaps with an exterior caulk. THIS COMPLETES THE HOUSING ASSEMBLY OF THE FAN
RkJQdWJsaXNoZXIy MTA3MzU=