GrowerSELECT - Chicken Breeder Nests Center Belt Installation Manual

Hog Slat Inc. Newton Grove, NC USA August 2019 15 Breeder Nests System Nest Closure (Actuated Tube) 24. Slide the Curtain Rod through the slot provided in each Partition panel and add cap to the end of curtain rod. 25. Connect curtain rods together using the male and female swedge until desired length is achieved. 26. Saw off curtain rod approximately ½ inch from end of nest and insert the Curtain Rod Cap to retain the pipe. 27. Slide the cut off end of the curtain pipe into the next nest section and repeat steps 24-26. 28. Extend actuation cord down through the Nylon Grommet and wrap around the curtain pipe and tie off. Curtain Rod Cap Saw and insert Curtain Rod Cap Swedge Connection Nylon Grommet Actuation Cord