Hog Slat Inc. Newton Grove, NC USA May 2023 23 Poultry Feed Systems Continue down the entire length of feeder line so that every joint is secured with a tube clamp. Figure below shows the proper location of the tube clamp on the tube joint. Clamp should be placed a minimum of 1/2” from belled end as shown. Do not tighten the clamp at this time. 4. Install the Hangers on the feed line tube at 8‘ or 10’ intervals determined by the suspension drop lines. Make sure the outlet drop hole is downward when the Hangers are installed so feed will be allowed to flow into feeder pan. 5. Install Cord Adjuster within 6” of feeder line. Diagram A shows the proper cord routing around the cord adjuster. The small holes are for 1/8” cord and larger holes are for 3/16” cord. Tie knot on end of cord as shown. If using cable drops, Diagram B shows the proper routing of the cable lock adjuster. Diagram A Diagram B
RkJQdWJsaXNoZXIy MTA3MzU=