Hog Slat Inc. Newton Grove, NC USA May 2023 24 Poultry Feed Systems 6. Following the installation of all drops, check drop lines before raising the feeder line. 7. Raise the feeder line to a convenient working height. 8. With the feeder line suspended, measure from the floor or ceiling to the auger tubes to level the system. 9. Before tightening each clamp: Make sure each tube is level – no sagging or slopping. Make sure straight end of tube is fully inserted in belled end of next tube. Make sure clamps are located as shown. Now tighten the Tube Clamps on the feeder tubes. Clamp the joints securely, but do not crush the tubes. Re-adjust all Cord Adjusters as needed and trim off any excess cord.
RkJQdWJsaXNoZXIy MTA3MzU=