Hog Slat Inc. Newton Grove, NC USA May 2023 30 Poultry Feed Systems HS8250 Mid-Line Control Pan The Mid-Line Control makes it possible to operate the feeding system when birds are confined away from the End of Line Control Unit. Place the Mid-Line Control feeder at least 2 pans away from the curtain or partition. 1. New Feeder Lines: Leave one feeder pan assembly off the feeder tube at the point where the Mid-Line Control needs to be placed. The feeder line can be assembled and suspended before attaching the Mid-Line Control. The Mid-Line Control can be attached to the feeder line when the other pans are installed. Existing Feeder Lines: Cut the Grill Support and remove the feeder pan at the location where the Mid-Line Control will be installed. New & Existing Feeder Line Tube Modifications: Before mounting Mid-Line control pan, enlarge feed outlet to approximately 1.00” using a step drill bit. Also, enlarge two outlets preceding the control pan. All burrs inside the tube must be removed. 2. Install the Mid-Line Control: a. Remove the two hex head screws on the control top b. Lift off the control top c. Cradle the feeder tube in the control housing. The feeder tube may have to be turned slightly to allow the pan to hang straight. d. Clamp the control in place by inserting tabs on the control top into the slots on the control body. Install and tighten the two hex head screws previously removed. Enlarge Outlets for 2 Pans Preceding Control Pan Mid-Line Control Pan Feed Flow
RkJQdWJsaXNoZXIy MTA3MzU=