Hog Slat Inc. Newton Grove, NC USA May 2023 48 Poultry Feed Systems Assembly: 1. Assemble (4) Side Sheet Hopper Panels (Ref# 1) as shown above in Figure 1 using Hex Bolts 1/4-20 X 0.5” (Ref# 17) and Hex Flange Nuts 1/4-20 (Ref# 14). Hand Tighten 2. Attach (4) Boot Hanger Brackets (Ref# 2) to the outside of the hopper body as shown above in Figure 1 using Hex Bolts 1/4-20 X 0.5” (Ref# 17) and Hex Flange Nuts 1/4-20 (Ref# 14). Hand Tighten 3. Attach (2) Cable Guide Brackets (Ref# 5) to outside of hopper body as shown above in Figure 1 using Hex Bolts 5/16-18 X 0.75” (Ref# 10) and Hex Flange Nuts 5/16-18 (Ref# 18). Hand Tighten 4. Attach Top Brace (Ref# 4 to outside of hopper body as shown above in Figure 1 using Hex bolts 5/16-18 X 0.75” (Ref# 10) and Hex Flange Nuts 5/16-18 (Ref# 18). Hand Tighten 5. Loosely assemble (2) Suspension Brackets (Ref# 7) and (2) Suspension Braces (Ref# 6) as shown above in Figure 1 using Hex Bolts 1/4-20 X 0.5” (Ref# 17), Hex Flange Nuts 1/4-20 (Ref# 14), Hex bolts 5/16-18 X 0.75” (Ref# 10) and Hex Flange Nuts 5/16-18 (Ref# 18). 6. Position assembled Suspension Brackets and Suspension Braces around the body of the Unloader as shown in Figure 3 below. Hand Tighten. Figure 3 7. Attach (4) Hopper Adjustment Brackets (Ref# 3) as shown above in Figure 1 using Hex bolts 5/16-18 X 0.75” (Ref# 10) and Hex Flange Nuts 5/16-18 (Ref# 18). Hand Tighten. 8. Suspend Lower Assembly using Clevis Pins (2) (Ref# 12) and Hairpins (2) (Ref# 11) from feed system support cables. 9. Slide bottom of hopper body into upper channel of the Unloader and secure with Cotter Pin (Ref# 16) as shown above in Figure 1. 10. Redirect suspension cables to travel through Cable guide bracket to provide lateral support. 11. Attach Hose Clamp (Ref# 8) to Top Brace (Ref# 4) using 1/4-20 X 1.5” Machine Screw (Ref# 13), Hex Flange Nuts 1/4-20 (Ref# 14), and Chain (Ref# 9).
RkJQdWJsaXNoZXIy MTA3MzU=